ADEO Services 74539 Manual De Instrucciones página 125

1. APPLICATION CONDITIONS OF CONCRETE MIXER
APPLICATION CONDITIONS:
The mixer is designed for operating under ambient air temperatures between 0oC and 40oC and for
installation at altitudes no more than 1000m above M.S.L. The surrounding humidity should less than 50%
at 40oC. It can be stored or transported under ambient temperatures between -25oC and 55oC.
2. SAFETY INSTRUCTIONS
UNDERSTAND YOUR MIXER:
• Read and understand the owner's manual and labels affixed to the mixer. Learn its application and
limitations as well as the specific potential hazards peculiar to it.
• Become familiar with the controls before operating this mixer.
STAY ALERT:
• Do not operate the mixer while under the influence of drugs, alcohol, or any medication that could affect
your ability to use it properly.
• Do not use this mixer when you are tired or distracted from the job at hand. Watch what you are doing at
all times. Use common sense.
AVOID DANGEROUS CONDITIONS:
• Make sure there is adequate surrounding workspace.
• Keep your work area clean and well lighted. Cluttered areas invite injuries. Keep area around the mixer
clear of obstructions, grease, oil, trash and other debris which could cause persons fall onto moving parts.
• Only use or operate the mixer on solid, flat, level ground that is capable to support the weight of the
mixer and its load to prevent the mixer from tipping over and use wedge blocks besides the wheels to
prevent the mixer sliding.
• Do not attempt to move the mixer when it is loaded and/or in operation.
• This mixer is intended for the production of concrete, mortar and plaster. It is not suitable for the mixing of
flammable or explosive substances. Do not use it in areas where fumes from paint, solvents or flammable
liquids pose a potential hazard.
INSPECT YOUR MIXER:
• Check your mixer before turning it on. Keep guards in place and in working order. Do not plug mixer with
motor cover off.
• Check all bolts, nuts, and screws for tightness before each use, especially those securing guards and drive
mechanisms.
• Vibration during mixing may cause these to loosen.
• Form a habit of checking to see that all the adjusting tools, shovels, hand trowels and other tools/
equipments are removed from mixer area before turning it on.
• Replace damaged, missing or failed parts before using it.
• Warning labels carry important information. Replace any missing or damaged warning labels.
125
EN