Mitsubishi Electric TPCA0A.1KA Serie Manual De Instrucciones página 14

6. Troubleshooting
Having trouble?
Draining water or motor rotation sound is heard.
Noise is louder than specifications.
Nothing appears in the wireless remote controller display, the display
is faint, or signals are not received by the indoor unit unless the remote
controller is close.
After battery installation/replacement of remote controller, part of
function cannot be used.
The operation lamp near the receiver for the wireless remote controller
on the indoor unit is blinking.
The indoor unit which is not operating becomes warm and a sound,
similar to water flowing, is heard from the unit.
7. Specifications
Model
Power source (Phase, voltage <V>, Frequency <Hz>)
Rated Input (Indoor only)
Rated Current (Indoor only)
Heater
Dimension (Height)
Dimension (Width)
Dimension (Depth)
Airflow (Low-Middle-High)
Noise level (Low-Middle-High)
Net weight
Model
Power source (Phase, Voltage <V>, Frequency <Hz>)
Rated Input (Indoor only)
Rated Current (Indoor only)
Heater
Dimension (Height)
Dimension (Width)
Dimension (Depth)
Airflow
(Low-Middle2-Middle1-High)
Noise level (Low-Middle2-Middle1-High)
Net weight
13
■
■
Location
examples
Noise levels
■
■
■
■
■
■
TPKA0A0241KA80A
<kW> 0.05
<A> 0.36
<kW> –
<inch>
<inch>
<inch>
<CFM>
<dB>
<lbs>
TPCA0A0241KA80A TPCA0A0301KA80A TPCA0A0361KA80A TPCA0A0421KA80A
<kW> 0.05
<A> 0.49
<kW> –
<inch>
<inch>
<inch>
DRY <CFM> 530-565-600-670
WET <CFM> 495-530-565-635
<dB> 33-35-37-40
<lbs>
Here is the solution. (Unit is operating normally.)
When cooling operation stops, the drain pump operates and then
stops.
Wait approximately 3 minutes.
The indoor operation sound level is affected by the acoustics of the
particular room as shown in the following table and will be higher than
the noise specification, which was measured in anechoic room.
High sound
absorbing rooms
Broadcasting
studio, music
room, etc.
3 to 7 dB
The batteries are low.
Replace the batteries and press the Reset button.
If nothing appears even after the batteries are replaced, make sure
that the batteries are installed in the correct directions (+, –).
Please check that the clock setting is completed. If clock setting is not
done, please complete.
The self diagnosis function has operated to protect the air conditioner.
Do not attempt to repair this equipment by yourself.
Turn off the power switch immediately and consult your dealer. Be sure
to provide the dealer with the model name.
A small amount of refrigerant continues to flow into the indoor unit
even though it is not operating.
TPKA0A0301KA80A
Single, 208/230, 60
0.05
0.36
–
14-3/8
46-1/16
11-5/8
635-705-775
39-42-45
46
Single, 208/230, 60
0.06
0.54
–
9-1/16
50-3/8
26-3/4
565-600-635-705 775-850-920-990
530-565-600-670 705-775-850-920
35-37-39-41
71
Low sound
Normal rooms
absorbing rooms
Reception room, Office, hotel
hotel lobby, etc. room
6 to 10 dB 9 to 13 dB
TPKA0A0361KA80A
0.08
0.57
–
705-810-920
43-46-49
0.09 0.11
0.83 0.97
– –
63
810-885-955-1025
740-810-885-955
37-39-41-43 39-41-43-45
79 86