Mitsubishi Electric TPCA0A.1KA Serie Manual De Instrucciones página 6

2. Parts Names
Notes
(Only for wireless remote controller):
■ When using the wireless remote controller, point it towards the receiver on the indoor unit.
■ If the remote controller is operated within approximately 3 minutes after power is supplied
to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
■ The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
fluorescent lights and strong light can affect the ability of the indoor unit to receive signals.
■ To avoid misplacing the remote controller, install the holder included with the remote
controller on a wall and be sure to always place the remote controller in the holder after
use.
Warning:
■ Do not dispose of the controller by yourself.
• Consult your dealer in case of disposal.
■ Never modify or repair the controller by yourself.
• Any deficiency caused by your modification or repair may result in an electric shock or
fire.
Consult your dealer about repairs.
■ Stop operation if the operation lamp on the controller's receiver blinks or if
an abnormality occurs.
• Leaving the controller in these conditions can lead to fire or breakdown. Report such
conditions to your dealer.
■ Never allow the alkaline batteries to short-circuit. Never disassemble, heat
or place them in fire.
• Doing so can cause the strong alkaline liquid to leak and possibly enter your eyes or
cause the batteries to explode or heat up, resulting in personal injuries, burning or
mechanical breakdowns. If strong alkaline liquid comes in contact with your skin or
clothes, wash it off with clean water. If it gets in to your eyes, wash them with clean water
and consult a doctor immediately.
Caution:
■ Do not drop the controller.
• Doing so may cause the case to crack and may disable control.
■ Do not wash with water.
• Doing so may cause an electric shock or breakdown.
■ Do not touch any control button with wet hands.
• Doing so may cause an electric shock or breakdown.
■ Do not press any control button with a sharp object.
• Doing so may cause an electric shock or breakdown.
■ Incorrect use of batteries can cause liquid leakage, explosion or heating and
may result in breakdown or personal injury. Adhere to the following.
(1) Do not recharge the batteries.
(2) Insert the batteries in the correct direction.
(3) Do not mix a new battery with an old battery or batteries of different types.
(4) Remove the batteries immediately when they have run out.
 Outdoor unit
5
Ref. Pipes
Indoor-Outdoor
Connection wire
Service Panel
Battery installation/replacement
1. Remove the top cover, insert two LR6 AA
batteries, and then install the top cover.
1
Top cover
Two LR6 AA batteries
Insert the negative (–) end of each
battery first. Install the batteries in the
correct directions (+, –)!
2. Press the Reset button.
Press the Reset button with an object
that has a narrow end.
After battery installation/replacement, please set
clock.
Without setting clock, you cannot use a part of
function of remote controller.
Power
Earth
2
3