Frigelux CA181BES Manual De Instrucciones página 33

1) Remove the upper right hinge cover (Figure 1 - 2).
2) Remove the screws attached to the top hinge with a Phillips screwdriver (Figure 3).
3) Replace the top hinge and top door limit block and door pad on the other side.
A. Remove the nut with sleeve. Take off the washer then remove the axes to the other side and fixed
(Figure 4).
B. Remove the door limit block (Figure 5).
C. Please remove another door limit block, with screw mounting on the door (figure 6).
4) Disassemble the screws fixed the bottom-hinge with hexagonal socket wrench (figure 7).
Note: The tilt angle of the fridge-freezer is less than 45°.
5) Replace the lower hinge on the other side and secure it with screws (figure 8).
6) Adjust the correct position of the door, fix the mid-hinge (figure 9).
7) Replace the top hinge (figure 10).
8) Set the top door right position, fix the top-hinge and the cover (figure 11).
9) Replace the leveler on the other side and adjust it to make sure the cabinet is level (Figure 12).
Door space requirements
The appliance door must be able to open fully as shown.
W ×D≥902×1052mm
7. TROUBLESHOOTING GUIDE
You can solve some common problems on your own and easily, thus saving the cost of a repair call. Try the
following suggestions to see if your problem can be solved without help from a troubleshooter.
Problems
power cut
Unusual noises
The device does
not cool enough
Unit does not cool
at all
Frost forms inside
your device
Solutions
During a power outage, frozen food will be preserved for approximately 9 hours.
Do not open the freezer too often during a power outage.
✓ Check the adjustment of the feet of your device and its stability.
✓ Check that it is not in contact with a wall.
✓ Check that all removable parts (bins, shelves, drawers, flaps, etc.) are in
place.
✓ Check if the temperature is set correctly. If not, adjust the temperature
appropriately.
✓ Check that you have not put a large quantity of food or hot food in your
appliance.
✓ Be careful not to open the door of your appliance too often or leave it open.
✓ Check that the door is tightly closed.
✓ Position your device away from any source of heat.
✓ Make sure that the ventilation around the device is respected.
✓ Check if your device is properly connected.
✓ Check if the circuit breaker in your house is not cut, if the fuse is not blown
or is not unscrewed.
✓ Be careful not to open the door of your appliance too often or leave it open.
33