Prior To Initial Use - Balance KH 5518 Instrucciones De Uso

Th e display remote control can be assembled
on a wall above the scales with or without a
wall holder. Th is is an alternative should the
scales only be used exclusively at one location.
For the assembly of the wall holder / display
remote control use either the double-sided
adhesive tape or both of the supplied plugs
and screws. Take note that there should be no
impediments between the scales and the in-
frared receiver of the display remote control.
Otherwise it could malfunctions with the dis-
play remote control.
If you wish to secure the wall holder with the
plugs and screws, with the assistance of the
wall holder transfer the correct distance bet-
ween the boreholes to the wall. Small drilling
mistakes can be evened out with the help of
the slotted holes.
†
Danger!
Please make sure no water or moisture can
enter the scales or display remote control unit.
Otherwise the scales and display remote con-
trol unit can be damaged beyond repair. Th is
could also cause danger of electric shock!
|
Warning!
Do not place the scales and display remote con-
trol unit in the immediate vicinity of heat sour-
ces such as ovens, heaters and other similar de-
vices. Otherwise the scales and display remote
control unit can be damaged beyond repair.
Th e scales and display remote control unit
can only be operated at temperatures between
10° and 40° Celsius. Th e scales should be kept
within this temperature range even while not
being used. Temperatures outside of this range
can result in malfunctioning or long-term da-
mages.
42 english

8. Prior to initial use

Before using the scales for the fi rst time, you
should enter your personal data. Ten memory
locations are available for storing your perso-
nal data. To store your personal data:
1
Take the display remote control unit in
your hand and press the on/off button
once. "Balance" will be displayed moving
across the screen.
2
Press and hold the i button until 1-10 is
displayed on the screen. As soon as you
release the i button, the number of one of
the ten memory locations will be displa-
yed on the screen.
3
You can choose one of the other ten me-
mory locations by pressing the up and
down buttons.
4
Press the i button as soon as the desired
memory location is displayed on the
screen. Now either lb or kg will blink on
the display screen.
5
Press the up and down buttons to switch
between ...
Ú
weight display in kg and height display in
cm according to the metric system and
Ú
weight display in lb (pounds) and height
display in feet and inches according to
the British measurement system.
Once the desired display mode (lb or kg)
is displayed, press the i button.