Toro 20200 Manual Del Operador página 15

Cutting Leaves
• After cutting a leaf-covered lawn, ensure that at least
half of the lawn shows through the cut leaves. You
may need to mow the leaves again.
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Every 50 hours
Before storage
Yearly
Important: Refer to the Engine Operator's Manual for additional maintenance procedures.
Maintenance Procedure
• Change the engine oil.
• Check the engine oil level.
• Check the blade-stop system operation.
• Check the air cleaner and clean or replace it, if necessary.
• Check the cutting blades.
• Wash underneath the machine.
• Charge the battery (electric-start model only).
• Change the engine oil.
• Service the blade-drive system.
• Charge the battery (electric-start model only).
• Empty the fuel tank before repairs as directed and before annual storage.
• Service the air filter; replace it more frequently in dusty operating conditions.
• Change the engine oil.
• Replace the blades or have them sharpened (more frequently if the blade edges
dull quickly).
• Check the spark plug (use a Champion RC12YC, NGK BKR5SE-11, or equivalent);
refer to the Engine Operator's Manual.
• Refer to your Engine Operator's Manual for additional maintenance procedures.
• If there are more than 5 inches (13 cm) of leaves on
the lawn, set the front cutting height 1 or 2 notches
higher than the rear cutting height.
• Slow down your mowing speed if the mower does
not cut the leaves finely enough.
15