Publicidad
Idiomas disponibles
Idiomas disponibles
Sharpening the planer blades
Always keep your blades sharp for the best perfor-
mance possible. Use the sharpening holder to remove
nicks and produce a fine edge.
► 1. Sharpening holder
First, loosen the two wing nuts on the holder and insert
the blades (A) and (B), so that they contact the sides
(C) and (D). Then tighten the wing nuts.
1
2
3
► 1. Wing nut 2. Blade (A) 3. Blade (B) 4. Side (D)
5. Side (C)
Immerse the dressing stone in water for 2 or 3 minutes
before sharpening. Hold the holder so that the blades
both contact the dressing stone for simultaneous sharp-
ening at the same angle.
Replacing carbon brushes
1
► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the chip cover.
1
5
4
► 1. Screwdriver 2. Chip cover
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
► 1. Brush holder cap
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
6 ENGLISH
1
1
2
Publicidad
