TFA 35.1133 Instrucciones De Uso página 12

TFA_No. 35.1133_Anleit_06_16
SUN - Funk-Wetterstation
range of approximately 1,500 km. Changeover from summer time or winter time is
automatic. In Daylight Saving Time "DST" is shown on the LCD. The quality of the
reception depends mainly on the geographic location. Normally there should be no
reception problems within a 1,500 km radius around Frankfurt.
Please take note of the following:
• The recommended distance to any interfering sources like computer monitors or TV
sets is at least 1.5 - 2 meters.
• Inside ferro-concrete rooms (basements, superstructures), the received signal is nat-
urally weakened. In extreme cases, please place the unit close to a window to
improve the reception.
• During nighttime, the atmospheric interference is usually less severe and reception
is possible in most cases. A single daily reception is adequate to keep the accuracy
deviation under 1 second.
4.2 Inserting the batteries in the basic station
• Open the battery compartment of the basic station.
• Insert two new batteries 1,5 V AAA. Make sure the polarities are correct.
• Close the battery compartment again.
• For a permanent backlight and to conserve battery power, use the supplied power
adapter.
• The batteries will operate as a backup power source in case of power failure.
4.3 Backlight
• Attention: Backlight in continuous operation only works with power adapter.
• To temporarily activate the backlight, press the light button on the front or the
LIGHT/SNZ button on the back.
5. Operation
• Important: During the reception of the signal for the outdoor temperature and the
time the buttons will not function.
22
17.06.2016 10:45 Uhr Seite 12
SUN - Funk-Wetterstation
• During the operation, all successful settings will be confirmed by a brief beep tone.
• The instrument will automatically quit the setting mode if no button is pressed for
a long period of time.
• Press and hold ▲ or ▼ button in the setting mode for fast running.
5.1 Manual setting of the clock and calendar
• Press and hold the MODE button to get into the setting mode.
• The year indication (2014 default) will be flashing.
• Press the ▲ or ▼ button to adjust the year.
• Press the MODE button and the setting sequence is shown as follows: Month, day,
date, month/day sequence (American version) or day/month (European version), the
language for the weekday (GE - default), the time zone (00 - default), 12 (PM
appears on the display after 12 h) or 24 hours display (24 hr - default), hours and
minutes. Press the ▲ or ▼ button to adjust them.
• The manually set time will be overwritten by the DCF time when the signal is
received successfully.
5.1.1 Setting of the time zone
• In the setting mode you can make the time zone correction (-12/+12).
• The time zone correction is needed for countries where the DCF signal can be
received but the time zone is different from the German time (e.g. +1=one hour
later).
• Press the ▲ or ▼ button.
• Confirm the setting with the button MODE.
5.1.2 Day-of-the week language
• Day-of-the week language: German (GE - default), French (FR), Italian (IT), Spanish
(SP), Dutch (DU), Danish (DA) and English (EN).
23