UFESA AE Sahara Manual De Instrucciones página 23

BATTERY REMOVAL
The appliance must be disconnected from the supply mains when removing the battery.
Make sure the battery broom is fully discharged.
Press the battery removal button and remove the battery from the product.
IMPORTANT WARNINGS
Prior to plugging in the product, check that your mains voltage is the same as the one in-
dicated on the product label. The mains connection cable must not be tangled or wrapped
around the product during use. Do not pull on the connection cord in order to unplug it.
Do not use, connect or disconnect the device to the mains with your hands or feet wet.
Proceed according to the conservation and cleaning section of this manual for cleaning.
Unplug the product immediately from the mains in the event of any breakdown or damage
and contact an authorized Technical support service. In order to prevent any risk of dan-
ger, do not open the device. Only qualified technical personnel from the brand' s Official
Technical support service may carry out repairs or procedures on the device. Any incorrect
use or improper handling of the product shall render the warranty null and void. Only an
authorized technical support service center may carry out repairs on this product. This
appliance is designed exclusively for domestic use, in no case should be a commercial or
industrial use. In case of misuse or tampering with the product, it will be out of warranty.
Do not use the appliance to vacuum liquids (water, etc), sharp objects (pins, pins, nails,
glass, etc), incandescent objects (matches, cigarettes). Never use the turbobrush to: Po-
lish floors, suck (Liquids, wet or damp dust, hot ash, burning objects, such as cigarettes,
matches, sharp and hard items, such us: razors, pins, thumbtacks, pieces of glass, etc),
flour, cement, plaster, printer or photocopier toner, etc.
B&B Trends, S.L. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.
ASSEMBLY INSTRUCTIONS
Main unit assembly:
1. Install the battery into the main unit by sliding it into the appropriate slot. It will "click"
into place.
2. Install the dust container by inserting the clip into the main unit from the correct direc-
tion, twist it and press it down into place. It will "click" to secure (FIG. 1).
Motorized power brush assembly:
Extension Tube: Use this for extended reach when using as an upright unit or for those
hard to reach places.
Motorized power brush: Use this for hard floors and carpets. Easily picking up dirt dust
and small debris.
Insert the connector of the motorized floor head into the base of the extension tube by
clicking it into place. Attach the extension tube into the motorized power brush, it will
"click" into place. Connect the main unit with the extension tube, you will hear the "click"
when it is correctly assembled (FIG. 2)
23