GreenWorks GD48GTE33 Manual Del Operario página 7

WARNING
Do not touch the cut-off blade.
1. Pull the edge guide until the open end on the slot.
2. Remove the screw from the guard with a Phillips
head screwdriver (not included).
3. Put the guard onto the trimmer head.
4. Align the screw hole on the guard with the screw
hole on the trimmer head.
5. Tighten the screw.
4.3 ATTACH THE WHEEL
Figure 4 - 5.
1. Remove the screw from the wheel with a Phillips
head screwdriver (not included).
2. Put the wheel onto the trimmer head.
3. Align the screw hole on the wheel with the screw
hole on the trimmer head.
4. Tighten the screw.
4.4 ASSEMBLE THE SHAFT
Figure 6.
1. Loosen the screw on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole
and slide the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
The release button must be fixed in the positioning
hole. Using the wrong hole could lead to personal
injury, or damage to the unit.
5. Tighten the screw with the hex wrench.
4.5 ATTACH THE AUXILIARY HANDLE
Figure 7.
1. Remove the knob from the handle.
2. Attach the auxiliary handle and lower clamp on
the shaft.
3. Set the auxiliary handle in the comfortable
position.
4. Put the bolt through the holes.
5. Tighten the auxiliary handle with the knob.
5 OPERATION
IMPORTANT
Before you operate the machine, read and
understand the safety regulations and the operation
instructions.
English
NOTE
Be careful when you operate the machine.
5.1 INSTALL THE BATTERY PACK
Figure 8.
• If the battery pack or charger is damaged, replace
them directly.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery slot.
2. Push the battery pack into the battery slot until
the battery pack locks into place.
3. When you hear a click, the battery pack is
installed.
5.2 REMOVE THE BATTERY PACK
Figure 8.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
5.3 START THE MACHINE
Figure 9.
1. Push the lock-out button and pull the trigger.
2. Push the speed button to adjust the speed
according to the grass condition.
5.4 STOP THE MACHINE
Figure 9.
1. Release the trigger to stop the machine.
5.5 ADJUST THE LENGTH OF THE CUTTING
LINE
Note: The product has an auto-feed head. If the
cutting line does not automatically advance, it is either
tangled or empty.
1. Release the trigger and wait for the trimmer head
to stop completely.
2. Start the trimmer at full speed to automatically
advance the line.
3. Repeat the above steps until you hear the distinct
sound of the line being cut by the cut-off blade.
Note:
• The cutting line will extend approximately 1 cm with
each stop.
• Do not pull and release the trigger handle too fast.
5
WARNING
WARNING
EN