Samsung SNC-300 Manual De Usuario página 10

Rear
1
2
1
Audio Out
2
Audio In
3
SDHC Memory Card Slot
System, SD, and Power
4
Indicators
5
I/O Port
6
Reset Button
06_ Preparation
6
For outgoing audio signals.
For incoming audio signals.
This is where you insert your SDHC memory card.
These indicators provide system, SD, and power status
information.
Used to connect the camera to an external device.
A_IN 1 and 2: These are alarm in ports.
GND: This is the GND port.
A_OUT 1 and 2: These are alarm out ports.
NOT USED: This port is not used.
Reverts all camera settings to their default.
When it is pressed for 3 seconds, the system indicator goes
out and the system reboots.
When the camera is reset, connection is possible only after the
basic network settings (IP address, subnet mask, gateway, etc.)
have been configured again using the IP installer program.
7 8
3
4
5