To reset the system
If the system abnormally operates or a problem occurs, you can restart or reset the system.
Click <SYSTEM> <RESET>.
The Reset window appears.
<Restart>: The Reset window appears.
<Factory Default>: Initializes the system settings to the factory settings and then restarts the system.
- <Except Network Parameter>: Initializes the system settings except network settings.
- <All>: Initializes all the system settings. Selecting this option is the same as pressing the
[FACTORY RESET] button on the rear panel of the main body.
After reset and restart, you have to connect to the system again.
It takes a few minutes until the system booting is completed.
You cannot connect to the system until the system booting is complete.
After running <Factory Default> <All>, you have to run <IP Installer.exe> program and
setup network settings such as IP address, Subnet mask, Gateway, etc., to connect to the
Internet.
52_
Setting Up