Wired Audio Input - Midland BTNEXT PRO Manual De Instrucciones

Long press the middle button until you hear "FM radio" from the voice announcement.
Now all the three main buttons are dedicated to the FM Radio (See Table C).
Press short the "Forward" or the "Backward" button to seek the FM Radio station.
When you press long the Forward or the Backward button, you can scan up or down the
6 recorded stations. A voice announcement will tell you the number of which memory
you are entering.
To save the station you are listening to, press the Forward and Backward buttons to-
gether for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the last recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal available for
the radio station you like to listen. The RDS system is OFF by default, if needed you can
toggle on/off the RDS pressing together the "Volume +" and "Volume –" buttons for 3
sec when the radio is on. A voice announcement will tell you the RDS status.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" button about
7 sec., until the Red light is on permanently.
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue LED will
flash three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the Midland
BTNEXT PRO
Enabling:
› Follow the same procedure up described; now the blue LED will flash once.
To exit the "Setup" mode, double click the "Middle" button.
C-Radio FM mode
Mode Forward button
FM Radio Short press: seek station up
Long press: Scan recorded
32
FM Radio with intercom
When you are in "FM Radio" mode it is not possible to manually open the intercom, you
can only open it using VOX feature (just talk) to the unit paired on the "Middle" button.
To manually activate the intercom you must switch to "Intercom" mode.
FM Radio in background
It is not possible to have the FM radio along with other audio sources. Any active audio
such as Intercom or coming from the VOL+ or VOL- connection, will pause the FM
radio.

Wired audio input

Your Midland BTNEXT PRO can be connected to a wired audio source, like an iPod (or
any other MP3 Player).
Listening to music
To listen to music from the wired input, connect the audio source using the optional
AUX cable. The volume buttons (Vol + and Vol -) can be used to adjust the volume of
the wired audio source (but not independently from the Intercom Volume). The AGC
system will automatically increase the volume on higher speed.
Attention: never set the volume of the MP3 Player to the maximum possible. Normally the
best level is about the 70% of the maximum.
Hint: We recommend that you perform a few tests adjusting the volume of your iPod/MP3
player so at the normal speed the Headset volume is suited to your needs. The AGC system
will automatically increase the volume on higher speed, so you don't need the VOL+ or
VOL- buttons to adjust it.
Middle button
Short press: On/off
Long press: Change mode
Rear button
Short press: seek station up
Long press: Scan recorded
www.midlandeurope.com