Publicidad
Idiomas disponibles
Idiomas disponibles
will be using the hedge trimmer for an extended time, it is advisable to take a break,
remove the battery, and oil the blades.
If the upper blades are aligned completely with the lower ones, start the hedge trimmer
and then stop it to offset the blades before lubrication
WARNING:
WARNING:
slip, heavy-duty protective gloves. Do not place your hand or fingers between
blades or in any position where they could get pinched or cut. NEVER touch
blades or service the unit with battery pack installed.
TRANSMISSION GEARS
LUBRICATION
The transmission gears in the cutting
head and power head assemblies need
to be lubricated periodically with gear
grease. Check the gear case grease level
approximately every 50 hours of operation
by removing the sealing bolts. There are
three sealing bolts: two on the cutting
head assembly (Fig. 10a) and one on the
power head assembly (Fig. 10b).
If no grease can be seen on the flanks
of the gear, follow the steps below to fill
with gear grease to 3/4 capacity. Do not
completely fill the transmission gear case.
1. Depending on which bolt you are
removing, lay the hedge trimmer on its
back or hold it on its side so that the
sealing bolt to be removed is facing
upwards (Fig. 10a & 10b).
2. Use the included hex key to loosen and remove the sealing bolt.
3. Use a grease gun (not included) to inject some grease into the bolt hole; do not
exceed 3/4 capacity.
4. Tighten the sealing bolt(s) after injection.
56-VOLT LITHIUM-ION COMMERCIAL 21" SHORT POLE HEDGE TRIMMER — HTX5300-P/HTX5300-P-FC
Do not oil while the hedge trimmer is running.
Blades are sharp. When handling the blade assembly, wear non-
10a
Cutting Head Assembly
10b
Power Head Assembly
Sealing Bolt
Sealing Bolt
29
Publicidad
