Publicidad
Idiomas disponibles
Idiomas disponibles
Via
| Assembly of Attendant Control
Assembly steps
1. Loosen the Velcro strap for
attaching the cable to the
control unit.
2. Remove the screws under the
control panel and
3. Put the control unit to one side.
4. Unscrew the star knob screw.
5. Pull out the holder for the
control panel to the front.
6. Push the rubber grip on the edge
(red) to the side (escort control
can be mounted on the right
and left).
1
1
2
Assembly of Attendant Control |
Bischoff & Bischoff GmbH | 03.08.2023 | Rev 01
Via
7. Handle rubber displaced.
8. Mount the bracket for the
attendant control unit in the
straight section of the
handlebar.
Note: The height can be adjusted
individually by turning.
Note: The position of the clamp
lever can be rotated after
tightening by pushing it up -
choose a position that does not
disturb the attendant or the
3
user.
9. Mount the control panel on the
bracket of the slider control.
Note: Make sure that the cables
are not crushed or stretched
when folding them up
10. Attach the control unit to the
back tube using the Velcro cable
fastener.
11. Ready mounted.
Note: When folding, watch out for
collisions with other
components; if necessary,
loosen the clamping lever and
4
tighten the twisted operating part.
2
Publicidad
