Publicidad
Idiomas disponibles
Idiomas disponibles
L-DESK RETURN AND ADJUSTABLE HEIGHT BASE ASSEMBLY CONTINUED
16. Place cable clips (S) in desired location to neatly
organize cables underneath the return desktop.
Cable clips can be attached using adhesive or
ST3.5 x 16 mm screws. (See Figure 19)
Figure 19
S
17. While the desk and adjustable height return are
separated, place them in the desired location.
CAUTION! Adjustable height L-desk should not
be moved once it is fully assembled.
PAGE 8 OF 33
18. Position the adjustable height return on right end of
the desk. Align the holes on the Z connectors (H)
with the holes inside the right leg (2). Insert three
M6 x 15 mm bolts (F) and fully tighten all bolts.
(See Figure 20)
NOTE: For left-hand configuration, position
adjustable height return on left end of desk.
Figure 20
19. Plug in power cord and raise/lower the return top
to ensure proper alignment. If there are alignment
issues, raise return top and loosen modesty panel
support bracket bolts (M). Align return top with
desktop and retighten bolts. (See Figure 21)
Figure 21
M
20. Insert three leg caps (J) into side of return leg frame
and one leg cap into top center edge of return
modesty panel. Insert two hole caps (K) into top
of return leg frame. Insert grommet caps (G) into
desktop and return top.
21. Adjustable height L-desk is now completely
assembled.
2
F
H
14
0323 IH-10357
Publicidad
