Clatronic ES 3643 Instrucciones De Servicio página 59

Water Tank
1. Open the lid to remove the water tank. Pull the tank with
both hands up and out. Replace the tank after cleaning
and drying.
NOTE:
The water tank has two hooks.
2. Hook the water tank into the two eyelets of the appliance.
3. Press the water tank slightly down for the valve to open.
Steam Nozzle
Clean steam nozzle and cover immediately after use. Dry
milk residue is difficult to clean.
1. Remove the cover. Turn slightly for easy removal. Use a
damp cloth to hold the steam nozzle with one hand!
2. Leave cover for some time in the warm sudsy water. In
this way milk residue is easily removed.
3. Wipe the steam nozzle on the appliance with a damp
cloth.
NOTE:
Fill a container with hot water to remove dry residue.
Place the container under the steam nozzle, so that it
is submerged.
4. After cleaning replace cover on the steam nozzle. Place
a heat-resistant empty container under the steam nozzle.
Operate the appliance as instructed under "Making
Cappuccino" points 5 and 6. After cleaning the steam
nozzle is again ready to use.
Decalcification
Scale deposits put the functionality of your appliance at risk. It
is necessary to decalcify the appliance regularly. The intervals
depend on use frequency and water hardness.
Decalcify with a commercial decalcifier for coffee machines.
1. Dose as instructed on the packaging or on the instruction
leaflet.
2. Operate the appliance as instructed for making espresso
until the tank is empty. Let the solution flow through the
group head (without filter holder).
WARNING:
• Rinse the water tank and let one full tank fresh
water flow through the group head to rinse out the
decalcifier residues.
• Do not use this water for making espresso.
58
ES 3643_IM
Storage
• Clean the appliance as instructed. Let the accessories dry
completely.
• We recommend that you keep the appliance in the original
packaging if the appliance will be not used for long
periods.
• Always keep the appliance out of the reach of children in a
dry, well ventilated place.
Troubleshooting
Problem Possible cause
The appliance The appliance has
does not no power supply.
function.
The appliance
has not been bled
before first-time
use.
The appliance is
faulty.
No coffee Switch the appliance off!
output.
The water tank is
empty.
The water tank
is not properly
attached; the valve
is not open.
The holes in the
filter holder and the
group head outlet
are blocked.
Air entrapped in the
heating circuit.
The coffee grounds
are too fine or
compressed too
much.
Scale deposits in
the appliance.
Solution
Test the socket with
another appliance.
Plug in the mains
plug correctly.
Check the main
circuit breaker.
Bleed the appliance
as instructed under
"First Use / Bleed-
ing".
Contact our
service center or a
specialist.
Fill the water tank
with fresh water.
Press the tank
slightly down for the
valve to open.
Clean filter holder,
filter and group
head outlet.
Generate steam
as instructed
under "Making
Cappuccino". Open
the steam control
knob all the way
towards "+".
Loosen the coffee
grounds. Spread
it evenly and only
slightly compress
with the tamper.
Decalcify the appli-
ance as instructed.
02.03.16