Descargar Imprimir esta página

CORBERO CPCGY202DN2 Instalación E Instrucciones De Uso página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

UNPACKING THE APPLIANCE
Remove all packaging before use and check to make sure that the appliance is in perfect condition.
If you have any doubts do not use the appliance and call your supplier.
Some parts on the appliance are protected by a plastic film. This protective film must be removed before the appliance is
used. We recommend carefully slitting the plastic film along the edges with a sharp knife or pin.
The packaging materials should carefully discard and not left within easy reach of children as they are a potential
safety hazard.
INSTALLING AND FIXING THE HOB
Your hob can be fitted to any worktop with a thickness of 40 to 50 mm,
accordance with No overhanging surface or cooker hood should be closer to the hotplate than 750 mm.
Fix in position in fig, 4. If fitting a 600-mm bridging unit above the 700-mm hob unit, the sides of adjacent cabinets may
be lower than 760 mm down to 334 mm provided they are resistant to heat and steam.
The hob has a special seal which prevents liquid from entering the cabinet Follow these instructions in order to correctly
apply this seal:
Detach the seals from their backing, that the transparent protection still adheres to the seal itself.
Turn over the hob and correctly position seal *E* (fig. 5) under the edge of the hob itself, so that the outer part of the seal
itself perfectly matches the outer edge of the hob. The ends of the strips must fit together without overlapping. Evenly
and securely fix the seal to the hob, pressing it firmly in place.
A
B
C
D
480 280 65 62 150 min.
Unit: mm
INSTALLATION OPTIONS
OPTION:
When fitting a gas hob above a drawer or standard housing unit, suitable precautions must be taken to prevent contact.
with the casing of the hob, which becomes very hot during operation. The recommended method for overcoming this
problem is to fix a wooden panel within the cabinet at a distance of 15mm below the underside of the hob (see fig 1). This
panel must have adequate ventilation to the rear.
The panel underneath the hob must be easily removable to allow for any servicing requirements.
E
F
G
90 min.
750 min.
4

Publicidad

loading

Este manual también es adecuado para:

Cpcgy111dnciCpcgy121dwciCpcgy101dnCpcgy212dnci2Cpcgy222dwci2