Publicidad
Idiomas disponibles
Idiomas disponibles
INSERTING AND FIXING THE HOB
Before inserting the hob into the work surface, place the adhesive seal (a) around the underside edge of the hob. It is
important to fix this gasket evenly, without gaps or overlapping to prevent liquids from seeping underneath the hob.
1. Remove the pan stands and the burner caps then turn the hob upside down, taking care not to damage the ignition
plugs and the thermocouples.
2. Place the gasket around the bottom edge of the hob as shown in the illustration overleaf (left).
3. Place the hob in the installation opening and push it down so that the hob is resting firmly on the cabinet.
4. Secure the hob in position using the fixing brackets supplied.
Secure the hob to the underside of the worktop using the fixings provided.
Screw one end of the bracket into the pre-drilled holes in the underside of the hob.
The other end of the bracket should be located underneath the worktop to secure the hob in position.
GAS CONNECTION
The appliance's gas inlet fitting is a 1/2" male threaded conic gas type in accordance with the ISO 7-1 standards. Make
the connection using rigid pipe.
When making the gas connection, it is important to place the gasket (A) in between the inlet pipe (C) and the elbow (B),
to ensure a gas tight seal.
GAS CONVERSION INSTRUCTIONS:
The manufacturers servicing instructions detail how authorized personnel may convert the gas hob from Natural gas to
Universal LPG or from Universal LPG to Natural gas. Contact the manufacturer or agent as required.
This appliance must be installed and connected in accordance with installation Regulations in force in the country
in which the appliance is to be used.
This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG and Natural gas must be
undertaken by a qualified person.
Once installed, check there are no leaks using a soapy solution (never a flame).
Screw
Fixing bracket
B
A
C
5
a
Worktop
Publicidad
