Connect Power - SoClean 2 Manual Del Usuario

PAP hose
(goes to mask)
Figure 3. Connect PAP hose to Injection fitting
Figure 4. Connect AC power
16 | CONNECTION STEPS/SUPPORTED PAP MACHINES AND ADAPTERS
Injection fitting
(hose goes to
SoClean)
Without humidifier:
1. Pull off the small Injection hose B from the inside of
the Injection fitting.
Note: If you are having difficulty disconnecting Injection
hose B, you may cut the tubing as close to the Injection
fitting as possible.
2. Attach the Injection fitting directly to your PAP machine.
3. Reconnect your PAP hose to the end of the
Injection fitting.
CAUTION: Please ensure that the black Injection hose
from the back of the SoClean 2 is connected to your PAP
before operating your SoClean 2.
Note: If you are having difficulty connecting to your PAP, an
additional part may be necessary. Contact SoClean.com.
4. Connect the PAP hose
Regardless of your humidifier, you can now connect
your PAP hose to the end of the Injection fitting, which
is connected to your PAP machine (Figure 3).

5. Connect power

Plug the AC adapter into the connector marked DC 12V,
1.5A on the back of the SoClean 2. The AC adapter
should be plugged into a wall outlet that is easy to access
and observe (Figure 4).
WARNING: In the event of loss of power to your home
or the SoClean 2, ensure that the correct clock time and
cycle start time are set on the SoClean 2 before using your
PAP machine. Failure to do so may result in the SoClean
device operating at an unexpected time.
6. Reconnect PAP equipment
You can now reattach the mask to the end of the PAP hose.