SoClean 2 Manual Del Usuario página 7

WARNING: Ensure the correct clock time and cycle
start time are set on your SoClean 2 before using
your PAP machine. Pay particular attention to the
AM/PM setting if using the 12-hr mode. Failure to do
so may result in the SoClean 2 device operating at an
unexpected time.
WARNING: In the event of loss of power to your
home or the SoClean 2 device, ensure the correct
clock time and cycle start time are set on your
SoClean 2 before using your PAP machine. Failure to
do so may result in the SoClean 2 device operating at
an unexpected time.
WARNING: Do not physically alter the Hose detect
switches on your SoClean 2 device. Inspect the
Hose detect switches regularly for damage or
inability to move up/down. Failure of the Hose
detect switches on your SoClean 2 may result in the
SoClean operating at an unexpected time.
WARNING: Keep away from water sources including
rain, bathtubs, sinks and pools. To clean, wipe with a
damp cloth. Do not submerge the SoClean device in
liquid or use chemical cleaners.
WARNING: Keep away from children. Do not place
any living thing inside the Disinfecting chamber
during use.
WARNING: Do not inhale from the Injection hose or
the Injection hose outlet on the back of the device.
WARNING: Do not breathe through your PAP mask if
the SoClean is operating a disinfecting cycle.
WARNING: Do not use in explosive air environments,
near gas vapours or other flammables, etc. Do not
place any flammable or ignitable items on top of the
SoClean 2.
WARNING: Keep the SoClean lid closed until the
green status light illuminates (approximately two hours
after completion of the disinfecting cycle).
WARNING: Do not remove gasket from the Hose
detect switch slot.
CAUTION: The lid gasket is removable. Ensure that
the lid gasket is installed properly before operating a
disinfecting cycle.
WARNING: Do not dismantle the SoClean 2.
CAUTION: Do not place Neutralising pre-wash
in the PAP reservoir. Neutralising pre-wash is for
cleaning your PAP equipment only.
CAUTION: Please ensure that the black Injection
hose from the back of the SoClean is connected to
your PAP before operating your SoClean device.
WARNING: If a strong ozone odour is detected
when the SoClean is operating, turn the SoClean
2 off by disconnecting the AC power adapter and
inspect the SoClean 2 for visible damage, such as
cracks in the enclosure or tubing along with tubing
connections.
WARNING: Do not route your PAP hose through
both Hose detect slots while or after using your
PAP. This may result in the SoClean device running
at an unexpected time.
ENG | 3