Publicidad
Idiomas disponibles
Idiomas disponibles
USER GUIDE
OPERATION INSTRUCTIONS
1.
Ensure the power switch is in the OFF position and the appliance is situated on a flat
surface.
2.
Check the cable to ensure it is in good condition and complies with the output voltage
required.
3.
Plug the appliance into the power source and turn it on. Flick the power switch to the
ON position and after a few seconds the LED display will illuminate.
4.
To change the temperature, press the
and DOWN button to decrease the value.
5.
To set the time, again press the
DOWN button to decrease the value.
6.
Once you have adjusted the time and temperature, hold down the
2-3 seconds until the screen stops flashing.
7.
Adjust the pressure by turning the pressure screw. It is important to ensure the correct
pressure is applied so that the print is good, and the consumable product doesn't
break. If it is set too heavy the press will be extremely hard to re-open and the handle
can break.
8.
When the LED display indicates the set temperature has been reached; place the
product onto the silicon pad on the lower plate. Re-align the silicon pad with the
bottom platen if needed.
9.
Then position the design face down on top of the product. Press the handle down
until the top platen meets the product. Lock the handle down into place and the timer
will automatically start.
10. When the time is complete the alarm will sound. Release the press handle and lift it
back up to the starting position. Take the product and design out of the machine using
insulated gloves.
06
button and use the UP button to increase
button and use the UP button to increase and
button for
Publicidad
