ADE CK 2301 Instrucciones De Operación página 35

Start-up
The alarm clock is powered by two 1.5 V R03 (AAA)
batteries.
1. Push the battery compartment cover upwards
and remove the cover.
2. Insert the batteries as shown on the bottom of
the battery compartment. Pay attention to the
correct polarity (+/-).
3. Replace the battery compartment cover and
push it down until it is secure. Once the batteries
are inserted, the clock switches to the receiving
mode, see next chapter.
Notes on changing the battery:
‚ Only use the battery type specified in the
"Technical Data".
‚ Always exchange all of the batteries at the same
time.
‚ Dispose of old batteries in an environmentally
friendly manner, as described in "Disposal".
Receiving the time signal
With the batteries in place, you will hear several
beeps, and all indications will appear briefly on the
backlit display.
After a short time, the display shows the measured
room temperature and indoor air humidity.
CK 2301 DCF radio-controlled clock
35