La Nordica GIULIETTA X 4.0 Manual Del Usuario página 25

TECHNICAL DEsCRIPTION
DEFINITION: PRODUCT ACCORDING TO EN 13240. THE APPLIANCE WORks As AN INTERMITTENT OPERATINg APPLIANCE.
The chimney stoves of La Nordica are suitable to heat living spaces for some periods or to support an insufficient centralized heating system.
They are ideal for holiday apartments and weekend houses or as an auxiliary heating system during the whole year.
AS FUEL, IT IS POSSIBLE TO USE WOOD LOGS.
The chimney stove is made of raw and enamelled meltings of cast iron. The hearth is internally sheathed with single sheets in cast iron and
inside it there is a turning and extractable grate. Thanks to the calibrated holes of that side, a contribution of pre-heated air inside the hearth
is guaranteed, obtaining a post-combustion, which increases the yield and reduces the exhaust gases emissions.
The hearth is equipped with a panoramic door with ceramic glass (resistant up to 700 °C). This allows a wonderful view on the burning flames
and avoids any possible output of sparks and smoke.
ACCEssORIEs
THE HEATING OF THE ENVIRONMENT IS MADE BY IRRADIATION: through the panoramic glass and the external hot surfaces of the stove,
the heat is radiated into the environment.
THE DEVICE IS EQUIPPED WITH REGISTERS OF PRIMARY AND SECONDARY AIR BY WHICH IT IS ADJUSTED THE COMBUSTION AIR.
A - sECONDARY Air register
Over the door of the hearth there is the secondary air control.
This regulator must be open (the lever must be moved to the right), especially for wood combustion, so that unburnt carbon undergoes
a post-combustion (see chapter NORMAL OPERATION).
Through this register it is possible to adjust the power of the stove. Leaving it slightly open, according to the flue of the chimney, it is
possible to keep the glass clean.
Picture 6
B - PRIMARY Air register
With the thermostat placed on the back of the right side of the stove, it is adjusted the passage of air through the ash drawer and the grate
in the fuel direction. The primary air is necessary for the combustion process. The ash drawer must be regularly emptied, so that the ash
does not obstruct the primary air entry. Through the primary air the fire is also kept alive.
DURING WOOD COMBUSTION, THE REGISTER OF PRIMARY AIR MUST BE OPENED ONLY FOR A WHILE, BECAUSE OTHERWISE THE
WOOD BURNS FAST AND THE STOVE MAY OVERHEAT. FOR THE CORRECT ARRANGEMENT (see paragraph NORMAL OPERATION).
THE ADjUsTMENT OF THE REgIsTERs necessary to reach the RATED CALORIFIC YIELD is the following one:
GIULIETTA X 4.0
ISETTA EVO 4.0
ISETTA CERCHI EVO 4.0
ISOTTA EVO
ISOTTA CERCHI EVO
ISOTTA FORNO EVO
C - IgNITION CONTROL Picture 6
Close —; Open +
LIgHTINg OPERATION :
Open the secondary air register (A), primary air register (B), open the ignition control (C), light up the fire.
The openings for air (primary and secondary) must be opened together just a little (you must open the eventual butterfly valve placed on
the pipe of smokes exhaust). See chapter LIGHTING.
After about 10 minutes, when the fire is lighted, close the thermostat (B) and the ignition control (C) and adjust the combustion course
with the controls (A).
LOAD THE FUEL:
BEFORE OPENINg THE HEARTH DOOR, OPEN THE IgNITION CONTROL (C), load the fuel, close the door and after about 5 or 10
minutes close the control (C). IMPORTANT: WE SUGGEST YOU TO OPEN THE DOOR VERY SLOWLY, TO AVOID THE EXIT OF SMOKES.
WARNINg: WHEN FUEL IS ADDED ONTO THE EMBERS IN THE ABSENCE OF A FLAME, A CONSIDERABLE AMOUNT OF FUMES
MAY DEVELOP. SHOULD THIS HAPPEN, AN EXPLOSIVE MIXTURE OF GAS AND AIR MAY FORM, AND IN EXTREME CASES AN
EXPLOSION MAY OCCUR. FOR SAFETY REASONS IT IS ADVISABLE TO PERFORM A NEW LIGHTING PROCEDURE WITH THE USE
OF SMALL STRIPS.
POKER
SERIES
Picture 6
Mass of fuel hourly
kg/h
1,85
2,0
2,5
2,6
( NO Isotta Forno EVO )
GLOVE
SERIES
(A )
SECONDARY Air
OPEN OPEN 3 mm
40% OPEN
OPEN
Picture 6
ENgLIsH
(B)
TERTIARY Air
PRIMARY Air
Picture 6
PRE-CALIBRATED
CLOSED PRE-CALIBRATED
OPEN 5 mm
CLOSED PRE-CALIBRATED
See chapter LIGHTING
/
25