Publicidad
Nozzle Hose
Tuyau de la tête d'aspiration
Boquilla de la manguera
Flat Screwdriver
Tournevis plat
Plano destornillador
Locking Tab
Release Hole
Trou de libération de
la languette de blocage
Bloqueando el agujero
del desbloquear de la
tabulatión
Removing Clogs
If the vacuum should become clogged:
➢ ➢ Ensure ON-OFF switch is OFF.
Suction
➢ ➢ Disconnect power cord from electrical
Inlet Cover
Couvercle de
l'entrée
d'aspiration
➢ ➢ Pull open suction inlet cover and
Cubierta de
aspiración
➢ ➢ Check the nozzle hose to make sure
➢ ➢ The nozzle hose may be removed at
➢ ➢ Check and replace any clogged
➢ ➢ Clean agitators.
Removing Handle
➢ ➢ Press downward on the handle
➢ ➢ After pressing downward on the
➢ ➢ Insert flat screwdriver into locking
➢ ➢ Remove handle assembly by pulling
- 44-
outlet.
remove any clogs.
it is free from obstructions.
the wand attachment end in order to
remove clogs.
filters.
height adjust button (see Telescopic
Handle section)
handle height adjustment button, pull
handle up until it stops
tab release hole located just in front
of the handle tube, pry screwdriver
toward the front of the vacuum. This
should release the handle locking
tab allowing the handle to be pulled
from the vacuum
straight out of vacuum
Publicidad
