Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Check the wheels for contact or excessive clearance with the surface below.
The deck wheels should have between ¼" and ½" clearance above the
ground. Proceed as follows to adjust the wheels:
a.
Raise the deck lift handle to its highest setting.
b.
Remove the front and rear deck wheels by removing the flange lock
nuts and shoulder bolts that secure them to the deck. See Figure 9.
c.
Place the deck lift lever in the desired mowing height setting.
d.
Reinsert the shoulder bolt (with each deck wheel) into the index
hole that leaves approximately ½-inch between the bottom of the
wheel and the pavement. Tighten the flange lock nut and shoulder
bolt to between 25-30 ft-lbs using a torque wrench.
NOTE: Refer to Adjusting the Deck in the Maintenance & Adjustments section of
this manual for more detailed instructions regarding various deck adjustments.
Figure 9
ASSEMBLY
Gas & Oil
The fuel tank is located at the outer/left of the dash and holds 3 gallons of gas.
Remove the fuel cap by turning it counter-clockwise. Use only clean, fresh (no more
than 30 days old), unleaded gasoline. Fill the tank no higher the bottom of the fill
neck to allow space for fuel expansion.
Use extreme care when handling gasoline. Gasoline is extremely flammable and
the vapors are explosive. Never fuel the machine indoors or while the engine is
hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition.
NOTE: Your tractor is shipped with oil in the engine. However, you MUST
check the oil level before operating. See the Engine Operator's Manual for
instructions on checking and adding oil. See the Service and Maintenance
section of this manual for oil changing procedures.
Always check the engine oil level before each use as instructed in the engine
operator's manual. Add oil as necessary. Failure to do so may result in serious
damage to your engine.
12
WARNING
CAUTION
Publicidad
