Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Loosen, but do not remove the flange lock nut on the right idler pulley and
the hex screw on the left idler pulley. See Figure 25.
Hex Screw
3.
Carefully remove the belt from around the idler pulleys and the spindle pulleys.
Avoid pinching injuries. Never place your fingers on the idler spring or
between the belt and a pulley while removing the belt.
4.
Route the new belt as shown in Figure 26.
NOTE: Use a 3⁄8" drive ratchet wrench as instructed in earlier steps when
routing the new belt.
SERVICE AND MAINTENANCE
Flange Lock Nut
Figure 25
WARNING
Figure 26
5.
Retighten idler pulleys.
6.
Remount the spindle covers if removed after step 1.
7.
Re-install the deck making sure the belt remains routed around the pulleys
as instructed.
8.
Pull the right side of the belt and place the narrow V side of the belt into the
PTO pulley. See Figure 27.
9.
While holding the belt and pulley together, rotate the pulley to the left.
Continue holding and rotating the pulley and belt until the belt is fully rolled
into the PTO pulley.
Changing the Transmission Drive Belt
Several components must be removed and special tools used in order to change
the tractor's transmission drive belt. See your qualified service dealer to have the
transmission drive belt replaced.
26
Figure 27
Publicidad
