Publicidad
HANGING THE CABINET
1. Remove door from cabinet, leaving protective corrugate caps on door, and place aside safely.
2. Lift the cabinet and place the cabinet onto the Mounting Bar.
3. Attach mounting clips [211-1405] onto the cabinet as shown (some components have been hidden for clarity).
- At least one clip per cabinet MUST be installed in a structural member (stud, etc.)
- At least two clips must be installed per cabinet.
4. If no stud or structural member is available, use the provided wall anchors [203-1349], making sure that each cabinet is supported
by at least 2 anchors. Drill a 5/16" (8 mm) hole for wall anchors and insert the wall anchor into hole until the anchor flange is flush with
the wall.
5. Use #10 X 2" screws [SS674] and tighten until there is a strong resistance. DO NOT OVER TIGHTEN
2A
3
Mounting Clip
© 2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
A
B
2B
2C
2C
5
SS674
6
Mounting Bar
Part no. CB-209-1348 09/13/21
PL Portray Cabinet Ganging Surface Mount Installation
Publicidad
