Publicidad
Idiomas disponibles
Idiomas disponibles
Just a slight loosening of the screw allows the saw
chain tension to be adjusted. After adjusting, retighten
the screw firmly.
008570
CAUTION:
For a while after a new saw chain is installed, it
•
tends to become loosened. From time to time
check the saw chain tension before use.
Low tension of saw chain may cause coming out
•
of place.
Installing or removing saw chain should be carried
•
out in a clean place free from sawdust and the like.
OPERATION
Lubrication
2
1
008571
Saw chain is automatically lubricated when the tool is in
operation.
Check the amount of remaining oil in the oil tank
through the oil inspection window.
To refill the tank, remove the cap from the oil tank
opening. The oil tank capacity is 80 ml.
After refilling the tank, always screw the provided oil
tank cap on the chain saw.
CAUTION:
When filling the chain saw with chain oil for the
•
first time, or refilling the tank after it has been
completely emptied, add oil up to the bottom edge
of the filler neck. The oil delivery may otherwise be
impaired.
As a saw chain oil, use oil exclusively for Makita
•
chain saws or oil available in market.
Never use oil including dust and particles or
•
volatile oil.
1. Oil tank cap
2. Oil inspection
window
3. Oil tank opening
3
When pruning trees, use botanical oil. Mineral oil
•
may harm trees.
Never force the chain saw when pruning trees.
•
Before cutting out, make sure that the provided oil
•
tank cap is screwed in place.
Hold the chain saw away from the tree. Start it and wait
until lubrication on saw chain is adequate.
Bring the tip guide/lower guide into contact with the
branch to be cut before switching on. Cutting without
bringing the tip guide/lower guide into contact with the
branch may cause the guide bar to wobble, resulting in
injury to operator.
Saw the wood to be cut by just moving it down.
Pruning trees
CAUTION:
Keep all parts of the body away from the saw
•
chain when the motor is operating.
Hold the chain saw firmly with both hands when
•
the motor is running.
Do not overreach. Keep proper footing and
•
balance at all times.
008575
1
008574
Bring the lower guide or tip guide (if equipped) into
contact with the branch to be cut before switching on.
Cutting without bringing the tip guide/lower guide into
contact with the branch may cause the guide bar to
wobble, resulting in injury to operator.
When cutting thick branches, first make a shallow
undercut and then make the finish cut from the top.
9
1. Lower guide
1
1. Tip guide
Publicidad
