Samsung LT28D310EW Manual De Instrucciones página 16

Issues
There is a plastic smell from
the TV.
The TV Signal Information
is unavailable in the Self
Diagnosis Test menu.
TV is tilted to the right or
left side.
There are difficulties
assembling the stand base.
The Broadcasting menu is
grey out (unavailable).
Your settings are lost after 30
minutes or every time the TV is
turned off.
You have intermittent loss of
audio or video.
You see small particles when
you look closely at the edge of
the frame of the TV.
The PIP menu is not available.
You turned the TV off 45
minutes ago, and it turned
on again.
The message "Scrambled
Signal" or "Weak or No
Signal" appears.
There are recurrent picture/
sound issues.
A reaction may occur between
the rubber cushion pads on
the base stand and the top
finish of some furniture.
The message "This file may
not be playable properly."
appears.
• You can keep your LED TV as optimum condition to upgrade the latest firmware on web site (samsung.com →
Support → Downloads) by USB.
Recommendation - EU Only
• Hereby, Samsung Electronics, declares that this LED TV is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
• This equipment may be operated in all EU countries.
• The official Declaration of Conformity may be found at http://www.samsung.com, go to Support > Search Product
Support and enter the model name.
[TD310_QSG]BN68-06025J-00L05.indb 16
Solutions and Explanations
• This smell is normal and will dissipate over time.
This function is only available with digital channels from an Aerial / RF / Coax connection.
•
• Remove the stand base from the TV and reassemble it.
Make sure the TV is placed on a flat surface. If you cannot remove the screws from the TV,
•
please use a magnetized screw driver.
• The Broadcasting menu is only available when the TV source is selected.
• If the TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes.
If you want to change the settings from Store Demo mode to Home Use, press the
button to select TV mode, and go to
• Check the cable connections and reconnect them.
• Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the
cables are flexible enough for long term use. If mounting the TV to the wall, we recommend
using cables with 90 degree connectors.
This is part of the product's design and is not a defect.
•
PIP functionality is only available when you are using a HDMI or components source.
•
• It is normal. The TV operates the OTA (Over The Aerial) function itself to upgrade firmware
downloaded whilst your watching TV.
• If you are using a CAM CARD (CI/CI+), check that it is installed into the common interface slot.
• If there is still a problem, pull the CAM CARD out of the TV and insert it into the slot again.
Check and change the signal/source.
•
• To prevent this, use felt pads on any surface of the TV that comes in direct contact with
furniture.
• This may appear because of high bit rate of content. Content generally will play but could
experience some playability issue.
English
16
→ Support → Use Mode.
MENU
SOURCE
2014-05-23 �� 1:12:24