Publicidad
Idiomas disponibles
Idiomas disponibles
Driving OnSlopes
Refer to the SLOPE GAUGE on page 7 to help determine
slopes
where you may operate the tractor safely.
i_ll
WARNING!
Do not mow on inclines
with a slope in
excess of 15 degrees (a rise of approximately
2-1/2
feet every 10 feet). The tractor could overturn
and
cause serious injury.
Mow up and down slopes, NEVER across.
Exercise extreme
caution
when changing
direction
on
slopes.
Watch for holes, ruts, bumps,
rocks, or other hidden
objects.
Uneven terrain could overturn
the machine.
Tall
grass can hide obstacles.
Avoid turns when driving
on a slope. Ira turn must be
made, turn down the slope. Turning
up a slope greatly
increases the chance of a roll over.
Avoid stopping when driving up a slope. If it is necessary
to stop while driving up a slope, start up smoothly and
carefully to reduce the possibility of flipping the tractor
over backward.
Engaging the ParkingBrake
NOTE:The
parking
brake must be set if the operator
leaves the
seat with the engine
running
or the engine will automatically
shut off.
To set the parking
brake:
1.
Press the brake pedal completely
down with your right foot
and hold it in that position.
2.
Push the parking
brake lever downward
and hold it in that
position.
3.
Remove your foot from the brake pedal.
4.
Release pressure from the parking
brake lever.
After completing
step 3, the brake pedal should
remain in the
clown position.
If it doesn't,
the pa rking brake is not engaged.
Repeat steps 1-4 to engage the parking
brake.
To disengage
the parking
brake, lightly
press the brake pedal.
i_
WARNING!
Never leave a running
machine
unattended.
Always disengage
PTO, set parking
brake, stop engine
and remove
key to prevent
unintended
starting
Setting TheCruiseControl
_i
ARNING!
Never engage
the cruise control
lever
while traveling
in reverse.
To set the cruise control:
1.
Slowly press the upper portion
of the drive pedal with your
right foot until the desired speed is achieved.
2.
Lightly
press the cruise control
lever downward
and hold it
in that position.
3.
Remove your foot from the drive pedal.
4.
Release pressure from the cruise control
lever
After completing
step 3, the drive pedal should
remain in the
down position
and the tractor
will maintain
the same forward
speed. If it doesn't,
the cruise control
is not engaged.
Repeat
steps 1-4 to engage
the cruise control.
To disengage
the cruise control,
lightly
press the drive pedal or
the brake pedal.
NOTE: Cruise control
can not be set at the tractor's
fastest
ground
speed. If the operator
should attempt
to do so, the
tractor will automatically
decelerate
to the fastest optimal
mowing
ground
speed.
To change the direction
of travel from forward
to reverse when
cruise control
is engaged,
press the brake pedal to disengage
the cruise control and bring the tractor to a complete
stop. Then
slowly press the rear portion
of the drive pedal with the ball of
your foot to travel in reverse.
Usingthe DeckLift Lever
To raise the cutting
deck, move the deck lift lever to the left, then
place it in the notch best suited for your application.
Operating the Headlights
The lamps are ON whenever
the ignition
key is rotated out of
the STOP position.
The lamps turn OFF when the ignition
key is
moved to the STOP position.
SECTION
S --
OPERATION
17
Publicidad
