Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaningthe Tractor
Any fuel or oil spilled on the machine
should
be wiped
off
promptly.
Do NOT allow debris to accumulate
around
the cooling
fins of the engine, the transmission's
cooling
fan or on any other
part of the machine,
especially
the belts and pulleys.
Slllart Jet
TM
Your tractor's
deck is equipped
with a water port on its surface as
part of its deck wash system.
Use the Smart Jet
TM
to rinse grass clippings
from the deck's
underside
and prevent
the buildup
of corrosive
chemicals.
Complete
the following
steps AFTER EACH MOWING:
1.
Drive the tractor
to a level, clear spot on your lawn, near
enough
for your garden hose to reach.
CAUTION:
Make certain the tractor's
discharge
chute is directed
AWAY from your house, garage,
parked cars, etc.
1.
Disengage
the PTO (Blade Engage), set the parking
brake
and stop the engine.
2.
Thread the hose coupler
(packaged
with your tractor's
Operator's
Manual) onto the end of your garden hose.
3.
Attach the hose coupler
to the water port on your decks
surface. See Fig. 6-2.
\
4_
5.
6_
Figure 6-2
Turn the water on.
While sitting
in the operator's
position
on the tractor, start
the engine
and place the throttle
lever in the FAST (rabbit)
position.
Move the tractor's
PTO (Blade Engage) into the ON
position.
7.
Remain in the operator's
position
with the cutting
deck
engaged
for a minimum
of two minutes,
allowing
the
underside
of the cutting
deck to thoroughly
rinse.
8.
Move the tractor's
PTO (Blade Engage) into the OFF
position.
9.
Turn the ignition
key to the STOP position
to turn the
tractor's engine
off.
10.
Turn the water off and detach
the hose coupler
from the
water port on your deck's surface.
11.
Repeat step 4- step 11 on the opposite
side of the cutting
deck.
After cleaning
your deck with the Smart Jet
TM
system, return to
the operator's
position
and engage
the PTO. Keep the cutting
deck running
for a minimum
of two minutes,
allowing
the
underside
of the cutting
deck to thoroughly
dry.
Lubrication
_i
ARNING!
Before lubricating,
repairing,
or
inspecting,
always disengage
PTO, set parking
brake, stop engine and remove
key to prevent
unintended
starting.
FrontWheels
Each of the front wheel axles and rims is equipped
with a
grease fitting.
See Fig. 6-3. Lubricate
with a No. 2 multi-purpose
grease applied
with a grease gun after every 25 hours of tractor
operation.
jr ............ L
..............................................................
..........................................
i::;:: .............
/
()
Figure 6-3
J
SECTION 6 --
MAINTENANCE
& ADJUSTMENTS
Publicidad
