Publicidad
Idiomas disponibles
Idiomas disponibles
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dishwashing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
-
When closing the door ensure that it does not touch any of the bottles.
-
If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the
racks along the compartment rails.
Adjusting the temperature
Control panel for models LM 1210 et LB 1650
1 – Stop/start button
2 – Lamp button
3 – Adjustment display screen
Control panel for models LB 1100 et LB 1540
1 – Stop/start button
2 – Lamp button
3 – Display screen for upper zone
4 – Display screen for lower zone
To switch the wine cabinet on or off, either press button 1.
All manuals and user guides at all-guides.com
USAGE
1
2
1
3
2
3
4
4 – Display screen
5 – Button for raising temperature
6 – Button for lowering temperature
5
4
6
5 – Button for raising temperature on upper
zone
6 – Button for raising temperature on lower
zone
5
6
36
Publicidad
