Operation of the Display
CAUTION
• Do not operate this product while driving your vehicle.
Deploying the Display
• Turn the ignition switch ON.
The display will be automatically deployed by the automatic close/open mode.
If the display is not automatically deployed, press the OPEN/CLOSE button.
Note:
• The automatic close/open mode will operate the display as follows.
* When the ignition switch is turned OFF while the display is deployed, the display will be closed
after approximately 6 seconds.
When the ignition switch is turned ON again (or turned to ACC), the display will be deployed
automatically.
* When using an AUDIO VISUAL MASTER UNIT, turning the power of either of these ON will
deploy the display automatically.
* Replacing the front panel will automatically deploy the display. (Refer to page 20.)
• The automatic close/open mode can be canceled. (Refer to page 9.)
• When the ignition switch is turned OFF after the display has been closed, turning the ignition
switch ON again (or turning it to ACC) will not deploy the display. In this case, press the
OPEN/CLOSE button to deploy the display.
6