Cord Assembly; Handle Assembly; Assembly Instructions - Sears Kenmore 116.33728 Manual Del Propietário

i i iiii!iYliiiii _i _ii ¸iiiiiiiiiiiiii!iiiiiiiiiiDiliiii :iiii :_:i _iiii_i _:iiii_iiiiii _ilii _:_:_i_i_i_i _iii_i_ii_ :_i ¸iii 'iii 'iii _ii _iii :iiiiiil _ii _iiiiiii _:iiiiiiiiiiiiiiiiiii _iiiiiiiiiiiiJil _ii _iii _iii 'ii _i _iiii! !
iiiii!!!!!iiiii!!!! ! i i!i i!i _i!!i!!! !iii!i ii! iiiiii!i!i i ii_i iiii!!!!iiii iiiiiiii!!i!i iii!!! iiiiiiiiiiiiiiill ii.
Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete.
Failure to do so could result in elec-
trical shock or injury.
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
HANDLE ASSEMBLY
Remove the two (2) handle screws located
in the body.
Position the handle as shown in the illustra-
tion below.
Screw
_ Handle
Screw
l
I
I
Connec_ons
Extension
Note: Move extension hose and power cord
out of the way during handle assembly.
When installing the handle, firmly press the
handle onto the body. Secure with handle
screws provided.
Do not overtighten.
Overtightening could strip the
screw holes.
Do not operate the cleaner with-
out the screws in place,
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove
the wire tie from the power cord.
Make sure the '
/
cord is /
power
placed into the
\
locking notch
\
on the body as
shown. This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.
f F Locking
/ Notch
Release
Upper Cord
Hook
' Cord
Hook
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.