Accessories; Repairs; Protection Of The Environment; Technical Specifications - Metabo SB 660 Instrucciones De Manejo

SBE 1010 NAFTA.book Seite 11 Mittwoch, 25. Januar 2006 3:07 15
Electronic signal indicator (10)
Rapid flashing - restart protection
(SBE 1010, SBE 1010 Plus)
When power is restored after a power failure, the
still switched-on machine does not start for safety
reasons. Switch machine off, then on again.
Slow flashing - carbon brushes worn
(SBE 1010, SBE 1010 Plus)
The carbon brushes are almost completely worn.
If the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorized service centre.
Permanently lit - overload
(SBE 1010 Plus)
In the event of prolonged overloading of the
machine, the power input is limited to prevent a
further inadmissible temperature rise of the motor.
Let machine cool down by letting it run at high
speed under no load.
f

11 Accessories

Use only genuine Metabo accessories.
If you need accessories, check with your dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
See page 4.
A Metabox
B Angle Drilling and Screwdriving Attachment
C Flexible Shaft
D Rubber Backing Pad
E Linen-backed Sanding Discs
F Drill Stand
(drill clamp can be rotated by 360°.)
G Moulding & Drill Stand
(Column with toothed rack and guide groove)
H Machine Vice
I Steel-wire End Brush
J Steel-wire Cup Brush
K Steel-wire Wheel Brush
L Fitting bit spring
For complete range of accessories, see
www.metabo.com or the main catalogue.

12 Repairs

Repairs to power tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed on the page
before the last page.
Please attach a description of the fault to the
machine.
13 Protection of the
Environment
Metabo's packaging can be 100% recycled.
Worn out power tools and accessories contain
considerable amounts of valuable raw and plastic
materials, which can be recycled.
These instructions are printed on chlorine-free
bleached paper.

14 Technical Specifications

Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
P = rated input
1
P = rated output
2
n *1 = no-load speed
1
n *1 = load speed
2
ø max = max. solid drill diameter
S max = max. impact rate
b = drill chuck clamping capacity
G = spindle thread
H = spindle with hexagon socket
m = weight
D = spindle collar diameter
During operation the noise level can exceed
85 dB(A).
Wear hearing protection!
*1 Impuls and Contact models:
High-energy high-frequency interferences can
cause deviations in working speed of up to 20%.
The speed returns to normal as soon as the
interference has faded away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH
ENG
11