SIGMA SPORT BC 700 Manual Del Usuario página 15

PLEASE READ CAREFULLY BEFORE USE AND CUT OFF THE SHORT |QE|
INSTRUCTION MANUAL AT THE END OF THIS LEAFLET TO TAKE " ^
WITH YOU ON YOUR RIDES
PACK CONTENTS (Fig 1)
- 1 SIGMA SPORT BC 700 cycle computer (1)
- 1 bracket with cable (2) and 1 sensor (3)
- 1 magnet (4)
- 1 casing (5)
- 1 small rubber band (black) (6)
- 1 large rubber band (black) (7)
- 1 large rubber band (grey) (8)
• 1. FIXING THE CYCLE COMPUTER BRACKET (Figs 2 4)
Remove the yellow protective film from the bottom ot the bracket (fig. 2).
Depending on the thickness of the handlebar, attach either the small or the large (black) rubber
band to the hook (P) (Fig. 1) below 'PRESS', take it under the handlebars and attach to the hook
(H) (figs. 1 & 3). Run the cable from the computer bracket to the fork by winding it round the front
wheel brake cable (fig. 4).
• 2. FIXING THE SENSOR (Figs 5 7)
NB. Please read the instructions for fitting the magnet (see next section) before you fix the positi-
on of the sensor.
Separate the upper section of the sensor by sliding towards 'OPEN' position (fig. 5).
Position the lower section of the sensor ('TOP' upwards) on the inside of the front fork. Attach by
running the grey rubber band around the fork (fig. 6).