cecotec CONGA ROCKSTAR DEEPCLEAN JALISCO Manual De Instrucciones página 51

Cleaning the Jalisco brush
Fig. 6
- Move the rotary brush release button with the finger and remove the cover on the same
side of the brush.
- Take one end of the brush out as shown on the image.
- It is important to clear and clean all the residues left in the brush's rotary axis.
- If you decide to wash the brush, you must air dry all the pieces. Assemble the pieces back
in order to use the brush again.
How to remove the battery
Press the battery release button and remove the battery as shown in figure 4. Store the battery
in a plastic bag and leave it in a dry place.
Vacuum cleaner storage
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place.
6. TROUBLESHOOTING
Problem
The vacuum cleaner does
not work.
The suction power
decreased and the vacuum
cleaner makes a lot of noise.
Insufficient operating time
after charging the vacuum
cleaner.
(The battery life may vary
according to the room
temperature).
Possible cause
Battery is discharged.
The metallic tubes, floor
brushes, battery or the
device itself are not properly
assembled.
The dirt tank is full.
The filter has too much dust,
the electric rotary brush inlet
is obstructed or the brush is
blocked.
Insufficient charge time.
Battery life has been exceeded.
Possible solution
Charge the vacuum cleaner.
Make sure all parts of
the vacuum cleaner are
correctly assembled.
Clean the dirt.
Clean or replace both
filters.
Clean the dust inside the
electric rotary brush.
Fully charge the battery
following the instructions
in this manual.
Batteries are easily
recycled. Go to the closest
maintenance point and buy
new batteries.
CONGA ROCKSTAR DEEPCLEAN JALISCO
ENGLISH
51