Publicidad
Idiomas disponibles
Idiomas disponibles
TO USE CRUISE CONTROL
The cruise control feature can be used for
forward travel only.
SYSTEM CHARACTERISTICS
The cruise controi should only be used
while mowing or transporting on relatively
smooth, straight surfaces. Other conditions
such as trimming at slow speeds may cause
the cruise control to disengage. Do not use
the cruise control on slopes, rough terrian
or while trimmimg or turning.
• With forward drive pedal (K) depressed to
desired speed, pull cruise control lever (J)
up and hold while lifting your foot off the
pedal, then release the lever,
To disengage the cruise control, depress the
brake pedal or tap on forward drive pedal.
TO ADJUST MOWER CUTTING HEIGHT
The position of the attachment lift lever (A)
determines the cutting height.
• Put attachment lift lever in desired cut-
ting height slot,
The cutting height range is approximately
1" to 4". The heights are measured from
the ground to the blade tip with the engine
not running. These heights are approximate
and may vary depending upon soil condi-
tions, height of grass and types of grass
being mowed.
• The average town should be cut to ap-
NOTE: Adjust gauge wheels with tractor on
a flat level surface.
1. Adjust mower to desired cutting height
(See "TO ADJUST MOWER CUTTING
HEIGHT" in this section of manual),
2. With mower in desired height ofcut posi-
tion, gaugewheels should be assembled
so they are slightly off the ground, install
gauge wheel inappropriate hole.Tighten
securely,
©
3/4
3. Repeat for all, installinggauge wheel
in same adjustment hole.
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch.
Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine. You must
remain fully and centrally positionedin the
seat to prevent the engine from hesitating or
cutting off when operating your equipment
on rough, rolling terrain or hills,
1. Select desired height of cut with attach-
ment lift lever.
2. Start mower blades by engaging attach-
ment clutch control.
proximately
2-I/2"
during
the cool sea-
TO STOP MOWER BLADES
Disengage attachment clutch control,
_IbCAUTION:
DO not operate the mower
son and to over 3" durine hot months
without either the entire grass catct)er,.an ....
.......... For
le0king tawnsl.........
mowerS S0eqUipped_orthe defiector shield
mow often and after moderate growth.
(S) in )lace.
For best cutting performance, grass over
6" in heightshould be mowedtwice. Make
the first cut relatively high; the second to
desired height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted when
they are slightly offthe ground when mower
is at the desired cutting height in operating
position. Gauge wheels then keep the deck
in proper position to help prevent scalping
in most terrain conditions.
12
Publicidad
