Create A IR STAND WOOD Manual Del Usuario página 8

1. Oscillation Knob
2. On/Off/Speed dial (0/I/II/III)
3. Tilt adjustment screw
4. Locking screw
5. Inner pipe
6. Height adjustment screw
7. Outer pipe
8. Base
9. Big washer
10. Small washer
11. Base locking screw
Remove all small parts from the box.
BASE AS SE M B LY
1. Loosen and remove the base locking screw and washers from the
bottom of the pipe.
2. Fit the pipe into the recess in the top side of the base; and
while holding it, turn it over to access underneath.
3. Align the big washer, small washer and the base locking screw
against the hole. Rotate the base locking screw to finish at-
taching the base to the fan body.
4. Now turn it right way up and place on a flat stable surface.
FA N HEAD AS SE MB LY
Loosen the locking screw on the bottom of the fan head and align the fan head to the top of the
inner pole. Tighten the locking screw to attach the fan head to the fan body.
8
E NGL I SH
PARTS LIST
ASSEMBLY
1
2
3
4
5
6
7
8
9
10
11