Hitachi Air home 800 XJ Serie Manual De Instrucciones página 4

DON' T TOUCH
• This appliance is not to be used by children or persons with reduced physical, sensory or mental
CAUTION
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction. Children must be supervised not to play with the appliance.
Names and Functions of Remote Controller
• This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is
controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
• Handle the remote controller with care. Dropping it or getting it wet may compromise its signal
transmission capability.
• After new batteries are inserted into the remote controller, the unit will initially require approximately
3~4 seconds to respond to commands and operate.
• When remote controller is not in use for about 3 minutes during OFF condition, indicated by
display, the LCD will turn off.
• During clock setting, the LCD will turn off about 3 minutes later if the remote controller is not in use.
• When pressing any button, the LCD will turn on.
• The LCD will not turn off during TIMER setting.
Off Mode Sign
Room Temperature Sensor
A temperature sensor inside
the remote controller senses
ambient temperature around
the remote controller.
Mode Selector Button
Use this button to select the
operation mode. Every time
you press this button the
mode will change from
(Dry)
SleepSense Button
Smart Eco Button
Use this button to set the
Eco mode.
Temperature Button
Room temperature setting.
Value will change quicker
when keep pressing.
Info Button
FrostWash Button
Up/Down Button
C o n r t l o
horizontal air deflector.
AQtiv-lon Button
Le /Right Button
Control the angle of the
Vertical air deflector.
Filter Sign Reset Button
PRECAUTIONS DURING OPERATION
• Do not touch the refrigerant pipe and connecting valve. Burns may result.
Signal Transmission(transmitting)/Receiving
(Heat)
(Auto) (Cool)
(Fan) cyclically.
h t e a n g e l f o h t e
Invalid Operation Sign
Shown at invalid setting or
operation
Transmission Sign
The transmission sign blinks
when a signal has been sent.
On/Off Button
Press this button to start
operation.
Press it again to stop
operation.
Fan Speed Button
Select the fan speed.
Powerful Button
Silent Button
My Mode Button
Wide Reach Button
Control the angle of the
Vertical air deflector.
LeaveHome Button
OK
Weekly Timer setting
Buttons
Press this buttons to set
weekly timer.
Reset Button
OK
On / Off Timer setting
Buttons
This buttons use to set On/
Off timer.
-4-
on the