Publicidad
Idiomas disponibles
Idiomas disponibles
connectors located at the back of the
monitor (1), as shown in Fig.8.
ATTACHING THE MONITOR.-
Release screws (3), Fig.8, at the back
of the monitor.
Next, slide the front of the monitor
onto the plate on top of the main post
(24) in the direction of the arrow,
Fig.8, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(3) removed previously.
13. FITTING THE CENTRAL
COVERS.-
Take post cover L (8L) and post cover
R (8R) and position them on the main
post (24), Fig.8. Now use the screws
(9) to attach them to the post.
14. FITTING THE FOCUS
BAR SIDE COVERS.-
Take the covers (10R), marked on the
inside with the letter "R", and position
them at the spindle end with the bars
on the right hand side, as shown in
Fig.9. Now use screws and (7-15) to
attach them. Carry out the same
procedure at the other end of the bar
using the covers (10L) marked on the
inside with the letter "L".
ATTENTION:
retighten all of the screws involved in
assembling
the
approximately a week of use as this
will prevent any strange noises and
possible damage.
FOCUS BAR SETTINGS.-
To adjust the angle of the feet for doing
exercise and the length of the focus bar
swing, turn knob (18) anticlockwise to
loosen it slightly, hold the foot and pull
It
is
important
machine
the knob outward Fig.3.
Sliding tube (23) into tube (16) will
reduce the length of focus bar swing
and pulling the tube (23) out will
increase the length of the swing Fig.3.
LEVELLING.-
Once the unit has been placed into its
fi nal position, make sure that it sits fl
at on the fl oor and that it is level. This
can be achieved by screwing the
adjustable feet (67A) up or down, as
shown in Fig.10.
MOVEMENT & STORAGE.-
The unit is equipped with wheels
(95W) to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it,as shown in
Fig.11. Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack (m) on the transformer
(113) into the connection hole (k) on
the main body (97) (bottom, rear of the
machine)
transformer into a 220 V mains supply,
Fig.12.
THE MANUFACTURER RESERVES
to
THE
SPECIFICATIONS
after
PRODUCTS
NOTICE
Do not hesitate to get touch with the
Technical Assistance Service if you
have
customer services (see last page in
manual)
16
and
then
RIGHT
TO
MODIFY
WITHOUT
any
queries
plug
the
THE
OF
ITS
PRIOR
by
phoning
Publicidad
