Publicidad
Idiomas disponibles
Idiomas disponibles
About the controls on the air conditioner
Vent Control
Thevent control islocatedbehindthe front grilleon the
right sideof the air dischargearea.WhenCLOSED, only
the air insidethe roomwill be circulatedand conditioned.
WhenOPEN, the vent allowsoutdoorfresh air exchange.
Toopenor closethe vent:
1. Remove thefront grille.
2. Remove thevent card screw.
3. Remove vent card,turn it overand replaceit by
locatingrear holein cardoverlocatingpin insideair
dischargeand reattachingscrewat front.
Theunit leavesthefactorysetat the CLOSE position.
ocatinghole
N_N
OPENposition
(Mesh end toward back)
Locating hole
CLOSE position
(Mesh end toward front)
Air Direction
Horizontal l ouvers
on thefront grille
letyoucontrol the
air directionup and
down.
front grille
tjustthe vertical
louvers side-to-side
to direct theair left
ht.
Auxiliary Controls - Dip Switches (location varies by model)
The auxiliary dip switch controls are located
behind the room cabinet-as shown in this figure.
The owner is responsible for checking switches
and ensuring they are in the desired position.
F
FanCycle/Continuous - Cool
X
Fan Cycle/Continuous - Heat (on some models)
\
_
Class 2 (on some models)
r_
Nofunction(reserved
Fan Cycle/Continuous
- Cool
When this switch is enabled (UPLit allows the indoor
fan to cycle on/off with the compressor. When this
switch is disabled (DOWN),it allows the indoor fan to run
continuously. The default setting is down (continuous).
r
FanCycle/Continuous - Cool
Fan Cycle/Continuous
- Heat (on some models)
When this switch is enabled (UP),it allows the indoor
fan to cycle on/off with the heater operation. When this
switch is disabled (DOWN),it allows the indoor fan to run
continuously. The default setting is UP(cyclic).
e/Continuous -
Heat (on some models)
Class 2 - Remote Thermostat (on some models)
When this switch is enabled (UP),it allows the unit
to operate with a Class2 Remote Control Wall
Thermostat. The unit controls are disabled.
The default setting is down (disabled).
- Eass2 (onsomemodels)
Publicidad
