Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Move the On/Auto/Off lever
to "ON/AUTO" position. The
compressor will start.
5.
Run the compressor for 15
minutes. Make sure the drain
valve is open and there is minimal
air pressure build-up in tank.
6.
After 15 minutes, close the drain
valve (clockwise). The air receiver
will fill to "cut-out" pressure and
the motor will stop.
The compressor is now ready for use.
Before
Each Start-Up:
1.
Place On/Auto/Off lever to "OFF".
2.
Pull regulator knob out, turn
counterclockwise
until it stops.
Push knob in to lock in place.
3.
Attach hose and accessories.
NOTE: The hose or accessory will
require a quick connect plug if the
air outlet is equipped with a quick
connect.
Risk of Bursting.
--
Too much air
pressure causes a hazardous
risk of
bursting. Check the manufacturer's
maximum
pressure rating for air
tools and accessories.
The regulator
outlet pressure
must never exceed
the maximum
pressure rating.
How to Start:
1.
Turn the On/Auto/Off lever to
"AUTO" and allow tank pressure
to build. Motor will stop when
tank pressure reaches "cut-out"
pressure.
2.
Pull the regulator knob out
and turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place. The compressor
is ready for use.
NOTE: Always operate the air com-
pressor in well-ventilated
areas free of
gasoline or other combustible
vapors.
If the compressor
is being used to
operate a sprayer DO NOT place near
the spray area.
A16751
14-ENG
Publicidad
