Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING UP THE REFRIGERATOR
Now that you have your new refrigerator
installed in place, you are ready to set up and enjoy the features and
functions
of the appliance.
By completing
the following steps, your Refrigerator
should be fully operational.
1. Place the refrigerator
in an appropriate
location with reasonable
clearance
between the walls and the
refrigerator.
Refer to installation
instructions
in this manual. (page 9, Selecting the best location for the refrigerator)
2. Once the refrigerator
is plugged
in, make sure the interior light comes on when you open the doors.
3. Set the Temperature
control to the coldest temperature
and wait for an hour. The freezer will get slightly
chilled and the motor will run smoothly.
4. After powering
the refrigerator,
it will take a few hours to reach the appropriate
temperature.
You can
store food and drinks in the refrigerator after the temperature
is sufficiently
low.
_
Check the accessories listed below.
Water filter
Hex wrench
Fastener
Required
Tools(Not
provided)
Philips screwdriver(+)
Flat-blade screwdriver(-)
Socket wrench (10mm)
Pliers
Allen wrench(3/16")
(Smm)
REMOVING THE REFRIGERATOR
DOORS
Some installations
require door removal to transport
the refrigerator
to its final location.
Do not remove the door/drawer
if it is not needed.
Before removing the door/drawer,
make sure you read
following
items.
A
Disconnect
power to the refrigerator
before
removing
the door or drawer.
WARNING
• Be careful not to drop, damage
or scratch the door/drawer
while removing them.
• Be careful not to get injured while removing the door/drawer.
• Reattach the door/drawer
properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting
energy due to improper
door seal.
Disassemble
the refrigerator
doors
Z_
Be careful
not to drop and scratch
the doors while
....... removing
the doors.
Disassemble
the refrigerator
doors
1. With the door opened,
remove the hinge top table (_])
with a flat-blade
screwdriver,
and close the door.
Remove the 3 screws holding down the top table
(_)
and remove it.
Sett]g
Up 9
Publicidad
