Mitsubishi Electric PLFY-WL-NEMU-E Serie Manual De Instrucciones página 22

6. Care and Cleaning
■
Filter information
Fri
83
Room
Cool Set temp. Auto
83
Mode Temp. Fan
Main Main menu
Maintenance
F1 F2 F3 F4
RETURN SELECT
MENU
HOLD
Maintenance menu
Error information
Filter information
Cleaning
Main menu: RETURN
Cursor
F1 F2 F3 F4
RETURN SELECT
MENU
OFF
HOLD
Filter information
Please clean the filter.
Press Reset button after
filter cleaning.
Main menu: MENU
Reset
F1 F2 F3 F4
RETURN SELECT
MENU
OFF
HOLD
Filter information
Reset filter sign?
en
Cancel OK
F1 F2 F3 F4
RETURN SELECT
MENU
OFF
HOLD
Filter information
Filter sign reset
Main menu: MENU
20
will appear on the Main display
in the Full mode when it is time to
clean the fi lters.
Wash, clean, or replace the fi lters
when this sign appears.
Refer to the indoor unit Instruc-
tions Manual for details.
Select "Maintenance" from the Main
menu, and press the [SELECT/
HOLD] button.
ON
OFF
Select "Filter information" from the
Maintenance menu, and press the
[SELECT/HOLD] button.
ON
Press the [F4] button to reset fi lter
sign.
Refer to the indoor unit Instructions
Manual for how to clean the fi lter.
ON
Select "OK" with the [F4] button.
ON
A confi rmation screen will appear.
Navigating through the screens
• To go back to the Main menu
....................... [MENU] button
• To return to the previous screen
....................... [RETURN] button
Fri
83
Room
Cool Set temp. Auto
83
Mode Temp. Fan
If two or more indoor units are connected, fi lter cleaning timing for each
unit may be diff erent, depending on the fi lter type.
will appear when the fi lter on the main unit is due for
The icon
cleaning.
When the fi lter sign is reset, the cumulative operation time of all units
will be reset.
The icon is scheduled to appear after a certain duration of operation,
based on the premise that the indoor units are installed in a space with
ordinary air quality. Depending on the air quality, the fi lter may require
more frequent cleaning.
The cumulative time at which fi lter needs cleaning depends on the model.
• This indication is not available for wireless remote controller.
Caution:
• Ask authorized people to clean the fi lter.
► Cleaning the fi lters
• Clean the fi lters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the fi lters against a solid object to knock off dirt and dust.
• If the fi lters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the fi lters to dry completely
before putting them back into the unit.
Caution:
• Do not dry the fi lters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the fi lters in hot water (above 50 °C, 122 °F), as this
may warp them.
• Make sure that the air fi lters are always installed. Operating the
unit without air fi lters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with fi lters to remove the dust of sucked-
in air. Clean the fi lters using the methods shown in the following
sketches.
When the is displayed on the
Main display in the Full mode, the
system is centrally controlled and
the fi lter sign cannot be reset.