Descargar Imprimir esta página

MTD 300 Serie Manual De Instrucciones página 15

Ocultar thumbs Ver también para 300 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Service
7
Augers
The augers are secured to the spiral shaft with four shear pins and
cotter pins. If you hit a foreign
object or ice jam, the snow thrower
is designed
so that the pins may shear. Refer to Fig. 5-1.
If the augers do not turn, check if the pins have sheared. Replace,
if needed, with
proper shear pins. Refer to Parts List for correct
part number.
CAUTION:
NEVER replace the auger shear pins with
standard
pins or fasteners. Any damage to the auger
gearbox
or other components,
as a result of doing
so, will NOT be covered
by your snow thrower's
warranty.
Replacing Belts
1.
Allow the engine to run until it is out of fuel. Do not
attempt
to pour fuel from the engine
2.
Remove the key to prevent
accidental
starting.
3.
Remove the self-tapping
screw shown
in Fig. 7-1, and press
the plastic tabs to release the belt cover. Pull the belt cover
up and out from around the engine and chute assembly.
Set it aside and save.
f
.........
/
AugerBelt
1.
Tip the snow thrower
up and forward
so that it rests on
the auger housing.
Remove the belt keeper (Refer to Fig.
7-3). Return the snow thrower
to its upright
position
to
complete
the following
steps.
2.
Slip the front auger belt off of the engine pulley, pushing
it
forward
and rolling
in off of the pulley. See Fig. 7-2.
Auger Belt
Figure 7-2
3.
Squeeze the auger control
handle to release the auger
brake, which is the tab that holds the belt onto the auger
pulley. Remove the belt.
4.
Replace with new belt after replacing
the drive belt.
J
Figure 7-1
15

Publicidad

loading