Honeywell CT50K Manual De Uso página 3

English: Page 1 • Français:
Mount thermostat base
1 Drill holes at pencil-marked
locations (3/16" holes for
drywall, 7/32" holes for
plaster).
2 Use hammer to tap anchors
into holes until flush with
wall.
3 Pull wires through thermo-
stat base and insert screws.
Check level if desired, then
tighten screws.
Connect wires
1 Match each labeled wire
with same letter on terminal.
2 Use a screwdriver to loosen
screw terminals, insert bare
wires beneath screws, then
tighten screws.
3 Push any excess wire back
into the wall opening.
Labels don't match?
If labels do not match letters on
thermostat, see table below.
Existing wires
R • RH • 4 • V
W • W1 • H
Page 6 • Español:
Connect to:
Terminal "R"
Terminal "W"
Página 11
3