Publicidad
Idiomas disponibles
Idiomas disponibles
A
WARNING:
Your router should never be
connected to power supply when you are
assembling parts, making adjustments,
installing or removing cutters, or when not in
use. Disconnecting your router will prevent
accidental starting that could cause sedous
injury.
INSTALLING/REMOVING
CUTrERS
See Figures 3, 4, and 5.
•
UNPLUG YOUR ROUTER.
WARNING:
Failure to unplug your router
could result in accidental starting causing serious
injury.
•
Place the posilock spindle lock into lock position. See
Figure 3. Note: If spindle does not lock, turn collet nut
with wrench, applying pressure at the same time to the
spindle lock with your thumb or finger. When lock
mechanism engages with notch in spindle, spindle lock
will slide into lock position.
A
WARNING:
To prevent damage to the
spindle or spindle lock, do not attempt to engage
spindle lock while motor is running. Always allow
motor to come to a complete stop and unplug it
before engaging spindle lock.
•
Place router upside down on workbench or lay it face
down on its side in order to gain easy access to collet
nut.
•
Place 15/16 in. wrench provided through back of router
base onto collet nut and turn counterclockwise
to
loosen, See Figure 4.
A
WARNING:
If you are changing
a cutter
immediately after use, be careful not to touch the
cutter or collet with your hands or fingers. They will
get burned because of the heat buildup from
cutting.
TO
TO TIGHTEN
COLLET NUT,
SPINDLE LOCK
INDICATOR LIGHT POSILOCK
SPINDLE LOCK
TOLOCK
Fig. 3
CUTTER
COMBINA_ON
WRENCH
COLLET
NUT
®
TO LOOSEN
COLLET NUT
Fig. 4
Publicidad
