Publicidad
Idiomas disponibles
Idiomas disponibles
For optimum
stereo reproduction, the
pair of speaker systems should be posi-
tioned
side by side approximately the
the same
distance
between
them and
the listener as shown on the illustration.
The
Dual
HiFi loudspeaker boxes are
equipped with special dome-type speak-
ers
which
radiate
the
high
frequen-
cies over a wide
range. Therefore
the
arrangement
of the speakers
is inde-
pendent of the listener's place. Adjust-
ment to suit the acoustics of the room
сап be made by means of the "Balance"
control.
Important! Make certain that the loud-
speakers connected to each channel have
a combined
impedance
of at least 4
ohms.
Failure
to observe this precau-
tion may cause a short circuit! Do not
attempt to connect several loudspeakers
in parallel to the Dual.
Centering stereo set-up
Press mono
key and adjust to medium
volume. Adjust balance control, so that,
when directly in front of the loudspeaker
set-up, the sound source appears to be
exactly in the center between
the two
speakers.
After switching over to the stereo (relea-
se the mono knob) the system is correct-
ly set for stereophonic listening.
When
playing
monaural
records,
it is
also advisable to follow the same ргіпсір-
le to
obtain
the best possible
room
arrangement.
Controls
© FM station key FM 4
Ф FM station key FM 2
© Bass control
O FM station key FM 3
Treble control
б) FM station key FM5
® Stereo indicator
@ Quadroeffect switch
Indication dial
(9 "Mono" key
"Phono" key
@ "Таре" (Band) key
Wave range key AM (LW)
® Wave range key AM (MW)
@ Wave range key AM (SW 2)
@ Wave range key AM (SW 1)
@ Wave range key FM (UKW)
@ ЕМ muting key
® On/off key (POWER)
@
Fine tuning selector knob
@ Connection for Matrix-Decoder
Ф Phono input (magnet)
® Selector switch (Kristall
@ Phono input (crystal)
@ Band tape output
Magn.)
Connecting signal sources
Three standard receptacles (DIN 41 524)
are provided for connecting Record Play-
er,
Tape
Recorder
and
similar
signal
sources,
PHONO GERAM
Fig. 4
PHONO MAGN.
Press the button PHONO and place the
throwover switch (located near the in-
put sockets) to position PHONO MAGN.
PHONO CERAM.
This input is provided for record players
with crystal pick-up cartridges or other
high impedance
signals.
Press button
PHONO
and place slide switch to posi-
tion PHONO CERAM.
TAPE
Tape recordings
Headphone connection
Publicidad
